Sika Plastocrete N AE | Plasticizers
Sika Plastocrete N AE is a concrete admixture in liquid form that acts as both a highly efficient plasticizer and as a waterproofing agent. Suitable for use in hot and tropical climatic conditions. Sika Plastocrete N AE provides the following properties: Improved workability without increased water content
Sika Plastiment-200 | Plasticizers
Water Reducing and Set Retarding Concrete Admixture Only set retarding, does not delay the hardening process. - Allow substantial cement reduction compared to plain concrete - Increase in ultimate strength - Good control of slump loss even at elevated ambient temperature - Reduced shrinkage and creep
Use of Water Reducers, Retarders, and Superplasticizer
The use of WRA is defined as Type A in ASTM C 494. WRA affects mainly the fresh properties of concrete by reducing the amount of water used by 5% to 12% while maintaining a certain level of consistency, measured by the slump as prescribed in ASTM C 143-90. The use of WRA may accelerate or retard the initial setting time of concrete.
Fosroc Conplast SP430 constructive solutions High performance
Conplast SP430 is compatible with other Fosroc admixtures used in the same concrete mix. All admixtures should be added to the concrete separately and must not be mixed together prior to addition. The resultant properties of concrete containing more than one admixture should be assessed by the trial mix procedure recommended on this data sheet to
Admixtures | Super Plasticizers - RussTech
RussTech carries a full line of super plasticizing concrete admixtures including ones that contain the new polycarboxylate technology. These high range water reducers have been specifically designed to increase strength while maintaining extended flowability at lower water to cementitious ratios in the concrete mix. SuperFlo 443. SuperFlo 2000RM.
- Is conplast rp264 compatible with other Fosroc Euco admixtures?
- Conplast RP264 is compatible with other Fosroc Euco admixtures used in the same concrete mix. If more than one admixture is used, they should be added to the concrete separately and not mixed together prior to being added. The resulting properties of concrete containing more than one admixture must be checked by prior testing.
- How to measure conplast mr260 admixture?
- The correct amount of Conplast MR260 should be measured using a suitable metering system. For best results, the admixture should be added to the concrete in the mixing water or directly into the mixer at the same time as the water. Contact Fosroc Euco's Technical Department for advice on the appropriate dosing equipment and its installation.
- How much conplast rp264 can be used for retarder delay?
- The usual dosage is between 0.25 and 0.6 litres of Conplast RP264 per 100 kg of cementitious material, including fly ash, slag and microsilica. Properties The following results were obtained at a temperature of 20°C: Water soluble chloride content (CI-): ≤ 0,10%. Alkali content (Na2O equivalent): max. 5 mass %. Application method: Retarder Delay
- What is a multifunctional plasticizer additive?
- Quick view Multifunctional plasticizer additive formulated from a mixture of synthetic and natural polymers, which can be used as plasticizer or superplasticizer depending on the dosage used. Multi-range water-reducing plasticizer. Consumption: 0.3 - 1% of the weight of the cement.
- How long does conplast rp264 last?
- Conplast RP264 has a storage period of 12 months if kept in a dry place and in its original, closed containers at a temperature between 2ºC and 40ºC. Freezing point: -3 ºC approx.
